EasyManuals Logo

Innotech MAXIM 1010 User Manual

Default Icon
60 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #21 background imageLoading...
Page #21 background image
Page 21
MAXIM Installation Instructions
© Mass Electronics Pty Ltd 2011
Chapter 2 – Mechanical Information
2-3.3 Installing on DIN Rail
As mentioned earlier the MAXIM Series controllers are designed to be mounted on DIN rail. The DIN
rail is a set of dierent standardized rails widely used for mounting industrial control equipment
inside equipment racks.
* All dimensions are in
millimetres.
Mounting Slot
18 x 5.2
To install a MAXIM Series controller on a DIN rail, align the DIN rail clip on the top edge of the DIN rail.
Push down on the controller until you hear the DIN rail release tab snap onto the bottom edge, as
illustrated in Figure 2-7 below.
To remove the controller, pull the DIN rail release tab down until it releases from the bottom edge of
the DIN rail, and then pull the bottom of the controller away and li up.
Figure 2-6:  DIN Rail Dimensions
Figure 2-7:  Installing MAXIM Controller on a DIN Rail

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Innotech MAXIM 1010 and is the answer not in the manual?

Innotech MAXIM 1010 Specifications

General IconGeneral
BrandInnotech
ModelMAXIM 1010
CategoryController
LanguageEnglish

Related product manuals