Inovance EtherCAT MD800 - Page 59

58
INOVANCE TECHNOLOGY EUROPE GmbH
MD800 EtherCAT Starting Guide_EN_v1.1_20211109.docx
BIT11: AI3 voltage (V)
BIT12: count value
BIT13: length value
BIT14: Load speed
display
BIT15: PID setting
F7-04
Display
parameter 2
0
BIT00: PID feedback
BIT01: PLC stage
BIT02: reserved
BIT03: Operating
frequency 2 (Hz)
BIT04: Remaining
running time
BIT05: reserved
BIT06: reserved
BIT07: reserved
BIT08: Linear speed
BIT09: Current power-
on time (Min)
BIT10: current
running time (Min)
BIT11: reserved
BIT12:
Communication
setting value
BIT13: reserved
BIT14: Main
frequency X display
BIT15: auxiliary
frequency Y display
If you need to display the
following parameters during
operation, set their corresponding
positions to
1. Set this binary number to
hexadecimal and set it in F7-04.
Pressing the shift key the
configured parameters can be
displayed
F7-05
Stop display
parameters
51
BIT00: set frequency
(Hz)
BIT01: bus voltage (V)
BIT02: DI input status
BIT03: DO output
status
BIT04: AI1 voltage (V)
BIT05: AI2 voltage (V)
BIT06: AI3 voltage (V)
BIT07: Count value
BIT08: length value
BIT09: PLC stage
BIT10: Load speed
display
BIT11: PID setting
BIT12: reserved
If you need to display the
following parameters during stop
state, set their corresponding
positions to 1,
Convert this binary number to
hexadecimal and set it in F7-05.
Pressing the shift key the
configured parameters can be
displayed
FP-01
Parameter
initialization
1
0: No operation
1: Restore factory
parameter mode 1
2: Clear record
information
4: Backup user
current parameters
Set the corresponding actions
when the inverter performs
parameter initialization.
0: No operation
The inverter does not perform
any operation.
1: Restore factory parameter
mode 1