Most of the inverter function
parameters are restored to the
factory parameters, but the
motor parameters
Maximum frequency (F0-10),
frequency command decimal
point (F0-22), fault record
Information, cumulative running
time (F7-09), cumulative power-
on time (F7-12),
The cumulative power generation
(F7-13) and cumulative power
consumption (F7-14) will not
recover.
2: Clear record information
Clear the inverter fault record
information, accumulated running
time (F7-09), accumulated up
Electricity time (F7-12),
cumulative power generation (F7-
13), cumulative power
consumption (F7-
14).
4: Backup user current
parameters
Back up the parameter settings
set by the current user.
501: Restore user backup
parameters
Restore the parameter setting
value backed up by setting FP-01
to 4.
To Next Page
Loading...
