Inovance EtherCAT MD800 - Page 63

62
INOVANCE TECHNOLOGY EUROPE GmbH
MD800 EtherCAT Starting Guide_EN_v1.1_20211109.docx
delay time for the change. Currently
only DI1, DI2, DI3 have set delay
F4-21
DI3 delay time
0.0s~3600.0s
When the state of the digital input
terminal DI changes, the inverter
delay time for the change. Currently
only DI1, DI2, DI3 have set delay
F4-22
DI input terminal
valid state setting 1
Ones place:
0: High level active
1: active low
Ten:
0: High level active
1: active low
hundreds:
0: High level active
1: active low
Thousands:
0: High level active
1: active low
Ten thousand:
0: High level active
1: active low
Set the effective mode of DI1~DI5
terminal through the ones place, tens
place, hundreds place, thousands
place and ten thousand place of this
parameter.
0: high level active
DI terminals (DI1~DI5) are valid when
connected to COM, and invalid when
disconnected from COM.
1: Active low
DI terminals (DI1~DI5) are invalid
when connected to COM, and valid
when disconnected from COM.
F4-23
DI input terminal
valid state setting 2
Ones place:
0: High level active
1: active low
Ten:
0: High level active
1: active low
hundreds:
0: High level active
1: active low
Thousands:
0: reserved
Ten thousand:
0: reserved
Set the effective mode of DI1~DI8
terminal through the ones place, tens
place, hundreds place, thousands
place and ten thousand place of this
parameter.
0: high level active
DI terminals (DI6~DI8) are valid when
connected to COM, and invalid when
disconnected from COM.
1: Active low
DI terminals (DI6~DI8) are invalid
when connected to COM, and valid
when disconnected from COM.
F4-25
AI1 hardware
source selection
0: no choice
1: Rectifier AI1
2: Rectifier AI2
101: Expansion card 1 AI1
102: Expansion card 1 AI2
201: Expansion card 2 AI1
202: Expansion card 2 AI2
Select the source of the analog
quantity/temperature input.
F4-27
AI2 hardware
source selection
0: no choice
1: Rectifier AI1
2: Rectifier AI2
101: Expansion card 1 AI1
102: Expansion card 1 AI2
201: Expansion card 2 AI1
202: Expansion card 2 AI2
Select the source of the analog
quantity/temperature input.
F4-29
AI3 hardware
source selection
0: no choice
1: Rectifier AI1
2: Rectifier AI2
101: Expansion card 1 AI1
102: Expansion card 1 AI2
201: Expansion card 2 AI1
Select the source of the analog
quantity/temperature input.