IS300 Series Servo Drive User Manual Preface
- 1 -
Preface
The IS300 series servo drive is specially designed for the permanent magnet synchronous
motor (PMSM). It provides wide coverage of capacity (rated current 2.1–725 A, rated power
400 W–400 kW).
In addition to standard servo drive functions, IS300 can also implement the control of
pumps. It is a cost effective servo drive in the middle to high power range of the existing
market.
This manual is a guideline for the selection, installation, parameter setting, on-site
commissioning and troubleshooting of the IS300 servo drive.
Before using the servo drive, please read this manual carefully so that you fully comprehend
the features of the product. Please ensure that the manual is kept safely before forwarding
to the end user.
Upon Unpacking, Please Ensure That:
1. The nameplate model and ratings of the servo drive match your order. The box contains
the product, the certificate of conformity, the manual and warranty.
2. The product is not damaged. If you find any omission or damage, please contact
Inovance or our agent immediately.
First-time Use
The person who uses this product for the first time must read the manual carefully. If they
have any doubt concerning some functions or performance, please contact our technical
support personnel for advice, thereby ensuring the correct use of our product.
With our commitment to constant improvement of the servo drive, our company may change
the information without further notice.
The IS300 series servo drive complies with the following international standards:
• IEC/EN 61800-5-1: 2003, Adjustable speed electrical power drive systems - Safety
requirements
• IEC/EN 61800-3: 2004, Adjustable speed electrical power drive systems – Part 3: EMC
requirements and specific test methods
Some products have passed the CE certification.
To Next Page
Loading...