Inovance IS 300 Series - 6.5 Wiring of ISMG Servo Motor

IS300 Series Servo Drive User Manual ISMG Servo Motor
- 67 -
6.5 Wiring of ISMG Servo Motor
6.5.1 Terminals of PCB Board
H8
J1 H10
J2J3
J4J5J6J7
MOTOX1
VER 3.0
2010-06-02
KTY-
KTY+ PTC- PTC+
W- W+ V - V+ U- U+ Z- Z+
COS-COS+
B+B-
SIN- SIN+
A- A+
EXC- EXC+
GND VCC
H9
AC2 AC1 PE
The signal types of the terminals are defined on the PCB board. AC1 and AC2 are power
supply (single-phase 220 V) to the cooling fan. AC1 and AC2 should be wired strictly
following the signs.
The matched signal lines of the IS300 servo drive are defined as below:
Signal Definition EXC- EXC+ SIN+ SIN- COS+ COS-
Adapted Encoder Cable Color Red Blue White Brown Yellow Green
Corresponding IS300 PG Card Pin 1 2 3 4 5 9
6.5.2 Definition of Power Terminals Matched with PCB Board
Note
• When wiring the main circuit, the phase sequence shall conform to the signs.
• Please connect PE terminal to the fixed screw in the connection box.