Inovance IS 300 Series - Page 47

Troubleshooting IS300 Series Servo Drive User Manual
- 46 -
■ Err05 (Over-voltage During Acceleration)
Err05
Check whether the servo drive
input voltage is too high .
Check whether there is an external force to
drive the motor to run during acceleration .
Check whether acceleration time is too short .
No
No
No
Contact the agent or our company .
Adjust the input voltage to
normal range .
Cancel the external force or
install a braking resistor .
Increase acceleration time .
Yes
Yes
Yes
Check whether braking unit and braking
resistor are installed .
Yes
No
Install the braking unit
and braking resistor .
■ Err06 (Over-voltage During Deceleration)
Err06
Check whether the servo drive
input voltage is too high .
Check whether there is an external force to
drive the motor to run during acceleration .
Check whether deceleration time is too short .
No
No
No
Contact the agent or our company .
Adjust the input voltage to
normal range .
Cancel the external force or
install a braking resistor .
Increase deceleration time .
Yes
Yes
Yes
Check whether braking resistor is installed .
Yes
No
Install the braking resistor .