Inovance MD500T75G - Page 183

MD500 User Manual 7. Description of Parameters
- 183 -
4. Set the running command
When F0-02 = 2 (the command source is communication) and A7-00 = 1 (the user programmable card is enabled), the drive running
is controlled by the setting of A7-08.
You can implement control of the AC drive via the PLC program by operating the corresponding D component.
Function Code Parameter Name Setting Range Default
A7-08 Setting running command via
the user programmable card
0 to 7
0: No command
1: Forward run
2: Reverse run
)RUZDUGMRJ
5HYHUVHMRJ
5: Coast to stop
6: Decelerate to stop
7: Fault reset
0
5. Set the frequency reference
When the frequency reference setting channel is communication and A7-00 = 1 (the user programmable card is enabled), the
frequency reference of the AC drive is determined by the setting of A7-06.
You can implement control of the frequency reference of AC drive via the PLC program by operating the corresponding D
component.
Function Code Parameter Name Setting Range Default
A7-06 Setting frequency reference via
the user programmable card
-100.00% to 100.00% 0.00%
The base value of this parameter is F0-10 (Max. frequency).
6. Set the torque reference.
When the torque reference setting channel is communication and A7-00 = 1 (the user programmable card is enabled), the torque
reference of the AC drive is determined by the setting of A7-07.
You can implement control of the torque reference of AC drive via the PLC program by operating the corresponding D component.
Function Code Parameter Name Setting Range Default
A7-07 Setting torque reference via
the user programmable card
-200.00% to 200.00% 0.00%
The base value of this parameter is rated motor torque.
7. 6HWWKHXVHUGHÀQHGIDXOWV
:KHQ$ WKHXVHUSURJUDPPDEOHFDUGLVHQDEOHG\RXFDQVHWWKHXVHUGHILQHGIDXOWV(UUWR(UUE\RSHUDWLQJWKH
FRUUHVSRQGLQJ'FRPSRQHQWWRFKDQJHWKHVHWWLQJRI$LQWKHUDQJHRIWR
Function Code Parameter Name Setting Range Default
$ Setting torque reference via
the user programmable card
0: No fault
WR8VHUGHÀQHGIDXOWFRGH
0
,IWKHVHWWLQJRI$LVRXWRIWKHUDQJHRIWRWKHVHWWLQJZLOOQRWWDNHHIIHFW
efesotomasyon.com