Inovance MD500T75G - Page 235

MD500 User Manual 8. Interfaces and Communication
- 235 -
AC drive fault description
AC Drive Fault Address AC Drive Fault Information
8000 0000: No fault
0001: Reserved
0002 Overcurrent during acceleration
0003: Overcurrent during deceleration
0004: Overcurrent at constant speed
0005: Overvoltage during acceleration
0006: Overvoltage during deceleration
0007: Overvoltage at constant speed
0008: Buffer resistor overload
8QGHUYROWDJH
000A: AC drive overload
000B: Motor overload
000C: Power input phase loss
000D: Power output phase loss
000E: Module overheat
000F: External fault
0010: Communication fault
0011: Contactor fault
0012: Current detection fault
0013: Motor auto-tuning fault
(QFRGHU3*FDUGIDXOW
0015: Parameter read and write fault
0016: AC drive hardware fault
0017: Motor short circuited to ground
0018: Reserved
5HVHUYHG
001A: Accumulative running time reached
%8VHUGHÀQHGIDXOW
&8VHUGHÀQHGIDXOW
001D: Accumulative power-on time reached
001E: Load lost
001F: PID feedback lost during running
0028: Fast current limit timeout
0RWRUVZLWFKRYHUHUURUGXULQJUXQQLQJ
002A: Too large speed deviation
002B: Motor over-speed
002D: Motor overheat
005A: Incorrect setting of PPR of the encoder
005B: Not connecting the encoder
005C: Initial position error
005E: Speed feedback error
efesotomasyon.com