Inovance MD500T75G - Page 261

MD500 User Manual 9. Peripheral and Options
- 261 -
Note
7KHVHWWLQJRIWKHMXPSHUVWDNHVWKHWRSYLHZZLWKWKHPDLQWHUPLQDOVDWWKHERWWRPRI
WKHFDUGDVWKHYLVXDODQJOH7KHMXPSHUVDUHVLONVFUHHQHGRQWKHFDUG
Ƶ
DIP Switch Setting
The DIP switches S2 and S3 of the MDCAN2 form a 8-bit DIP switch to set the CAN bus baud rate and communication equipment
DGGUHVV$VVKRZQLQWKHIROORZLQJÀJXUHELWVDQGDUHXVHGWRVHWWKHEDXGUDWHZKLOHELWVWRDUHXVHGWRVHWWKH&$1RSHQ
address. When the DIP switch is set to ON, it indicates 1. When the DIP switch is set to OFF, it indicates 0.
ON
1234
ON
1234
1234 1234
Baud rate
CANopen address
You can set the baud rate via the DIP switch according to the following table.
Bit Setting Baud Rate
12
0 0 125 kbps
0 1 250 kbps
1 0 500 kbps
1 1 1 Mbps
The bits 3 to 8 are used to set the CANopen communication address. 3 is the highest bit and 8 is the lowest bit. You can set the
FRPPXQLFDWLRQDGGUHVVWRWKURXJKWKHVHVL[ELWVDFFRUGLQJWRWKHIROORZLQJÀJXUH
Bit Setting Communication Address
345678
0 0 0 0 0 0 Reserved
0000011
0000102
0000113
... ...
11111163
Ƶ
Indicators
Indicator State Description
PWR (in red) ON Power-on is normal.
OFF Power-on is abnormal. Check whether the installation is proper.
ERR (in red) ON The communication of the AC drive times out.
Flashing quickly The CANopen address is set incorrectly.
Flashing twice The CANopen messages emergently.
RUN (in green) ON The CANopen enters the "Operational" state.
Flashing The CANopen enters the "Pre-Operational" state.
OFF The CANopen enters the "Stopped" state.
Ƶ
Terminal Wiring
)RUZLULQJDQGXVHRIWKHWHUPLQDOVRI&$1RSHQ&DUGVHHWKHWHUPLQDOZLULQJSDUWLQWKHVHFWLRQ([WHQVLRQ&$1OLQN&DUG
(MD38CAN1).
If you purchase the MD38CAN2 card, the related user manual will be delivered together with the product. See the user manual for
details.
efesotomasyon.com