Inovance MD500T75G - Page 67

MD500 User Manual 4. Operations
- 67 -
7KHYDOXH\RXVHWIRUIXQFWLRQSDUDPHWHU)3GHWHUPLQHVZKHWKHUWKHRSHUDWLQJSDQHOGLVSOD\VWKHTXLFNYLHZXVHUGHÀQHGDQG
WKHTXLFNYLHZXVHUPRGLÀHGIXQFWLRQJURXSV7KHEDVHPRGHLVDOZD\VDYDLODEOH
Table 14 Setting FP-03 to select the quick-view display modes
Value of FP-03 8VHUPRGLÀHG*URXS 8VHUGHÀQHG*URXS
00 Not displayed Not displayed
01 Not displayed Displayed
10 Displayed Not displayed
11 (default) Displayed Displayed
Ƶ
Editing Function Parameters
This editing method is mostly used in on-site commissioning.
ƕ Pressing
and in Level I menu is to quickly change the function parameter group.
ƕ Pressing
and in Level II menu is to quickly increase or decrease the function parameter number.
ƕ Pressing
and in Level III menu is to quickly increase or decrease the function parameter value. To save the setting,
press
ENTER
. To cancel the setting, press
PRG
.
4.4.2 Saving and Restoring Settings
After you change the value of any function parameter, the MD500 saves the new value locally so that it remains effective when you
next power on the AC drive. The MD500 also retains alarm information and cumulative running time statistics.
The MD500 allows you to make a separate external backup of parameter settings. This feature allows you to load a set of parameter
settings during commissioning, or to restore a set of parameter settings after completing a maintenance or repair operation on the
MD500.
You can also restore the default parameter settings, or clear the running data by using the function parameter FP-01. See ## for a
description of function code FP-01.
Function parameter
working area
Factory parameters
Parameter setting backup
DSP
Power-down retentive
parameters (F-14 toF-44)
E
2
PROM
FP-01 = 1 +
ENTER
Restore factory parameters
FP-01 = 4 +
Back up parameter settings
FP-01 = 501 +
ENTER
Restore backup parameters
ENTER
FP-01 = 2 +
Clear the recorded
fault information.
User-modified parameters
ENTER
ENTER
efesotomasyon.com