Inovance MD500T75G - Page 80

5. Quick Setup MD500 User Manual
- 80 -
CONTINUE Para. Parameter name Default Commissioning
if it is VF control
Set VF parameters
F3-00 9)FXUYHVHOHFWLRQ 0
/LQHDU9)
0XOWLSRLQW9)
6TXDUH9)
SRZHU9)
SRZHU9)
SRZHU9)
SRZHU9)
5HVHUYHG
9)FRPSOHWHVHSDUDWLRQ
9)KDOIVHSDUDWLRQ
SETTING RANGE: 0 to 11;
F3-01 Torque boost 0.0
0.0 to 30.0 %;
NOTE: if it is 0, then auto torque boost is activated, and
it is recommended to use auto torque boost.
F3-02 Frequency limit of torque boost 50.00
0.00 Hz to maximum output frequency
F3-03 0XOWLSRLQW9)IUHTXHQF\) 0.00
0.00 Hz to F3-05
F3-04 0XOWLSRLQW9)YROWDJH9 0.0
0.0 to 100.0 V
F3-05 0XOWLSRLQW9)IUHTXHQF\) 0.00
F3-03 to F3-07, Hz
F3-06 0XOWLSRLQW9)YROWDJH9 0.0
0.0 to 100.0 V
F3-07 0XOWLSRLQW9)IUHTXHQF\) 0.00
F3-05 to rated motor frequency F1-04, Hz
F3-08 0XOWLSRLQW9)YROWDJH9 0.0
0.0 to 100.0 V
Trial RUN Use operational panel, or digital input terminal, or communication control, to
VWDUWLQYHUWHUDQGVHHLIWKHUXQQLQJSHUIRUPDQFHVDWLVÀHV\RXUDSSOLFDWLRQ
If yes, then go forward to next step, if NO, then wrap back to check.
CONTINUE Para. Parameter name Default Commissioning
efesotomasyon.com