INTEGRA Metering CALEC ST III User Manual

Operation
44 / 56
3-140-UM-EN-02
Display Meaning Visible Editable
Ref
Threshold for return temper-
ature in option TGR
Overstepping: register E2 Un-
dercutting: register E3
According to calculator function Programming mode
6.6.9 Outputs
This menu is only available if the output hardware module is installed in the device.
Display Meaning Visible Editable
Nr Output number Yes Yes
Fct Output function Yes Service mode
SIG Signal type of the output (A)
Depends on the output function
Fct
Service mode
IMP
Pulse value for the function
of the output (A)
Depends on output function Fct Service mode
SIG (B, C) Depends on output function Service mode
GW1 Limit value 1 (B, C) Depends on output function Service mode
GW2 Limit value 2 (C) Depends on output function Service mode
HYS
Hysteresis of the output (B,
C)
Depends on output function Service mode
CNT
Pulse counter / seconds over-
stepped (A, B, C, D, E)
Depends on output function Service mode
ACT
Effective direction of the out-
put (B, C, D, E, F)
Depends on output function Service mode
STA Actual status (A, B, C, D, E) Depends on output function Yes
STA Actual status (F) Depends on output function Service mode
6.6.10 I-Out
This menu is only available if the I-OUT analog hardware module is installed in the device.
Display Meaning Visible Editable
Nr Output number (1…4) Yes Yes for selection
Fct Output function Yes Service mode
SIG
Type of analogue output (A,
B)
Depends on output function Service mode
0/4 Value at 0 mA or 4mA (A, B) Depends on output function Service mode
20 Value at 20 mA (A, B) Depends on output function Service mode
do Simulation mA value (C) Depends on output function Service mode
Err
Current output in case of er-
ror (A, B)
Depends on output function Service mode
STA Current value (A, B) Depends on output function Yes
6.6.11 Units
Display Meaning Visible Editable
Eu Energy unit Yes Programming mode
Ed
Number of decimal places for
energy unit
Yes Programming mode
V
Unit and number of decimal
places for volumes unit
Yes Programming mode

INTEGRA Metering CALEC ST III Specifications

General

Brand	INTEGRA Metering
Model	CALEC ST III
Category	Measuring Instruments
Language	English