INTEGRA Metering CALEC ST III User Manual

Operation
46 / 56
3-140-UM-EN-02
Display Meaning Visible Editable
Trm
Turn termination resistor
on / off
Yes Service mode
6.6.16 LON
On the CALEC ST® III, no specific menu is available for the LON hardware. All parameters are set directly
through the protocol interface itself.
6.6.17 KNX
On the CALEC® ST III, no specific menu is available for the KNX hardware. All parameters are set directly
through the protocol interface itself.
6.6.18 LoRa
This menu is only available if the LoRa hardware module is installed in the device.
Display Meaning Visible Editable
InT
Interval of transmission (in
seconds)
Yes Service mode
AT
Type of application (OTAA,
ABP)
Yes Service mode
SET
Selection of type of frame
(data package det number)
Yes Service mode
CFM
Selection of the frame struc-
ture
Yes Service mode
WAN Lora Wan version Yes No
FW Firmware version Yes No
6.6.19 Config
This menu is only visible if the “Service Mode” is entered and validated. If you do not validate, you will only
get a temporary access for 1 minute.
Display Meaning Visible Editable
Loc Safety key Yes Yes
Loc Safety user level Yes Service mode
TYP Type of temperature sensor Yes Service mode
MED
Type of glycol mixture (op-
tion GLY)
Yes, if option GLY is set Service mode
CON
Concentration in % of the
glycol mixture (option GLY)
Yes, if option GLY is set Service mode
SMU
Creeping quantity suppres-
sion
Yes Service mode
Rem
Remanence time for the ac-
tual flow (keeping time of
display)
Yes Service mode
dpQ
Damping factor for actual
performance / flow value
Yes Service mode
dPt
Damping factor for actual
temperature value
Yes Service mode
RES
Reset counter, alarm, logger
and other values
Yes Service mode
dt-
Limit value for display of dT-
shortfall
Yes Service mode

INTEGRA Metering CALEC ST III Specifications

General

Brand	INTEGRA Metering
Model	CALEC ST III
Category	Measuring Instruments
Language	English