26
En
When you connect an u-capable Onkyo component, you
must configure the input display so that u can work
properly.
This setting can be done only from the front panel.
• DOCK can be selected for the TV/CD, Game or VCR/DVR
input selector, but not at the same time.
• Enter the appropriate remote control code before using the
remote controller for the first time (➔ 84).
• Always turn down the volume before connecting your head-
phones.
• While the headphones plug is inserted in the Phones jack, the
Headphone indicator, speaker/channel indicator FL and FR
lights.
• When you connect a pair of headphones, the listening mode is
set to Stereo, unless it’s already set to Stereo, Mono or Direct.
• Only the Stereo, Direct, and Mono listening modes can be used
with headphones.
Using the Easy macro command in the Easy macro mode,
you can sequentially operate Onkyo components with sim-
ple commands by simply pressing one button. The default
actions are described below. Press Activities to start the
Easy macro command.
Once the AV controller has entered the normal macro
mode, all of Activities will automatically switch to the
normal macro mode. In this case, pressing All Off will set
only the AV controller to Standby mode.
*1
Depending on the start-up time of Blu-ray Disc/DVD player,
the AV controller may not activate this playback command. In
this case, press 1 on the remote controller.
Turning Off the Components
*1
When My Music is selected, with the default settings, this
will not be performed.
*2
With some televisions, the power may not be turned off (or
enter standby).
Changing the Input Display
1
Press TV/CD, Game or VCR/DVR so that “TV/
CD”, “GAME” or “VCR/DVR” appears on the
display.
2
Press and hold down TV/CD, Game or VCR/DVR
(about 3 seconds) to change the input display.
Repeat this step to select “MD”, “CDR”, “DOCK”
or “TAPE”.
For the TV/CD input selector, the input display
changes in this order:
For the Game input selector, the setting changes in
this order:
For the VCR/DVR input selector, the setting
changes in this order:
Using Headphones
Connect a pair of stereo headphones with a stan-
dard plug (1/4 inch or 6.3 mm) to the Phones
jack.
TV/CD
MD
CDR
DOCK
TAPE
Using Easy Macros
Press My Movie, My TV, or My Music.
My Movie (default):
1. The TV connected to the AV controller is turned
on.
2. The Onkyo DVD player connected to the AV
controller is turned on.
3. The AV controller is turned on.
4. The input selector of the AV controller is set to
“BD/DVD”.
5. The player starts playback.
*1
My TV (default):
1. The TV connected to the AV controller is turned
on.
2. The cable set-top box connected to the AV con-
troller is turned on.
3. The AV controller is turned on.
4. The input selector of the AV controller is set to
“CBL/SAT”. You can enjoy cable TV.
My Music (default):
1. The Onkyo CD player connected to the AV con-
troller is turned on.
2. The AV controller is turned on.
3. The input selector of the AV controller is set to
“TV/CD”.
4. The player starts playback.
• Once you start the Easy macro command, you cannot use
other Activities during the execution. If you want to
operate other components halfway, press All Off to stop
and press desired Activities.
Press All Off.
1. The connected component stops and turns off.
2. The AV controller turns off.
3. The TV connected to the AV controller turns off
(Standby).
*1*2
To Next Page
Loading...
Need help?
General
