EasyManuals Logo

Integra DHC-40.2 User Manual

Integra DHC-40.2
100 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #85 background imageLoading...
Page #85 background image
85
En
You’ll need to enter a code for each component that you
want to control.
Note
The remote control codes provided are correct at the time of
printing, but are subject to change.
Integra/Onkyo components that are connected via u are
controlled by pointing the remote controller at the AV con-
troller, not the component. This allows you to control
components that are out of view, in a rack, for example.
If you want to control an Integra/Onkyo component by
pointing the remote controller directly at it, or you want to
control an Integra/Onkyo component that’s not connected
via u, use the following remote control codes:
BD/DVD
30627
:
Integra/Onkyo DVD player without u
TV/CD
71817
:
Integra/Onkyo CD player without u
11807:
TV with p
8
If you can control component, press Receiver,
use q/w to select “Works”, and then press
Enter.
The “Remote Mode Setup” menu appears.
If you cannot control component, press
Receiver, use q/w to select “Doesn’t work(Try
next code)” and press Enter.
The next code appears.
9
Press Setup.
The setup menu closes.
Entering Remote Control Codes
1
Look up the appropriate remote control code in
the separate Remote Control Codes list.
The codes are organized by category (e.g., DVD
player, TV, etc.).
2
While holding down Remote Mode to which you
want to enter a code, press and hold down Dis-
play (about 3 seconds).
The Remote Mode button lights.
Note
Remote control codes cannot be entered for Receiver
and Zone2.
Only TV remote control codes can be entered for TV.
Except for Receiver, TV and Zone2, remote control
codes from any category can be entered as Remote
Mode. However, these buttons also work as input selector
buttons ( 24), so choose a Remote Mode that corre-
sponds with the input to which you connect your compo-
nent. For example, if you connect your CD player to the
CD input, choose TV/CD when entering its remote control
code.
3
Within 30 seconds, use the number buttons to
enter the 5-digit remote control code.
Remote Mode button flashes twice.
If the remote control code is not entered success-
fully, Remote Mode button will flash once slowly.
Remote Control Codes for Integra/
Onkyo Components Connected via u
1
Make sure the Integra/Onkyo component is con-
nected with an u cable and an analog audio
cable (RCA).
See “Connecting Integra/Onkyo u Components”
for details ( 19).
2
Enter the appropriate remote control code for
Remote Mode.
BD/DVD
31612:
Integra/Onkyo DVD player with u
TV/CD
71327:
Integra/Onkyo CD player with u
42157:
Onkyo cassette tape deck with u
Port
81993:
Onkyo Dock with u
See the previous section for how to enter remote
control codes.
Note
When using a cassette tape deck connected via u, press
and hold TV/CD to switch to TAPE.
3
Press Remote Mode, point the remote controller
at the AV controller, and operate the component.

Table of Contents

Other manuals for Integra DHC-40.2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Integra DHC-40.2 and is the answer not in the manual?

Integra DHC-40.2 Specifications

General IconGeneral
BrandIntegra
ModelDHC-40.2
CategoryController
LanguageEnglish

Related product manuals