55
En
To correct a character:
• To name a radio preset, use Tuner to select AM or FM, and then
select the preset (➔ 31).
• You cannot enter a custom name for SIRIUS radio presets.
•“Name Edit” is not operable when the input selector is set to
“NET/USB”.
To restore a custom name to the default, erase the custom
name by entering an empty white space for each letter.
Picture Adjust
Using “Picture Adjust”, you can adjust the picture qual-
ity and reduce any noise appearing on the screen.
To view the TV picture while setting, press Enter. To
return to the previous screen, press Return.
• If you are using the analog RGB input, the following settings
have no effect: “Film Mode”, “Edge Enhancement”, and
“Noise Reduction”.
•“Picture Adjust” is not operable when the input selector is set
to “NET/USB”.
■ Game Mode
Off
:
Game Mode off.
On:
Game Mode on.
If video signal delay occurs during playback on a video
component (i.e. game console), select the corresponding
input source and set the “Game Mode” setting to “On”.
The delay will decrease but in return the picture quality
will become poor.
■ Wide Mode
*1
This setting determines the aspect ratio.
• When the “Game Mode” is set to “On”, this setting is fixed at
“Full”.
4:3:
Full:
Zoom:
Wide Zoom:
Auto
:
According to the input signals and monitor output
setting, the AV controller automatically selects the
“4:3”, “Full”, “Zoom” or “Wide Zoom” mode. For
the monitor output setting (➔ 45).
1
Use q/w/e/r to select “ ”(Left) or
“ ”(Right), and then press Enter.
2
Press Enter several times to select the incorrect
character (The cursor moves one letter each
time Enter is pressed).
3
Use q/w/e/r to select the correct character,
and then press Enter.
BD/DVD
Shift All Erase
Shift All Erase
4-4. Name Edit
Name
abcde f gh i j k lm
nopqr s t uvwxyz
1234567890
–`
Space
Back SpaceShift OK
{}|: <>
?
ABCDEFGH I JKLM
NOPQRSTUVWXY Z
;
,
./
[]
Space
Back SpaceShift OK
!
@
#$%
^&
()_ ~
+10 CLR
+10 CLR
Name input area
Shift
*1
:
Switches the displayed character.
Space:
Enters a space character.
(Left)/ (Right):
Selected when the cursor is moved within the Name
input area.
BackSpace
*2
:
“BackSpace” moves the cursor backward one char-
acter space. In addition, “BackSpace” deletes the
character to the left of the cursor.
OK:
Selects when the entry is complete.
*1
You can also be performed on the remote controller by
using +10.
*2
Press CLR on the remote controller, you can delete all
characters in the input.
To Next Page
Loading...
Need help?
General
