44
En
Advanced Setup
The on-screen setup menus appear on the connected TV
and provide a convenient way to change the AV control-
ler’s various settings. Settings are organized into 9 catego-
ries on the main menu.
Carry out the settings by using the on-screen display.
• This procedure can also be performed on the AV controller by
using Setup, arrow buttons, and Enter.
• During Audyssey MultEQ
®
Room Correction and Speaker
Setup, messages, etc., that are displayed on the TV screen will
appear in the Display.
On-screen Setup Menus
This manual describes the procedure using the
remote controller unless otherwise specified.
a Input/Output Assign
(➔ 45)
f Miscellaneous
(➔ 58)
b Speaker Setup
(➔ 48)
g Hardware Setup
(➔ 59)
c Audio Adjust
(➔ 51)
h Remote Controller
Setup (➔ 84)
d Source Setup (➔ 53) i Lock Setup (➔ 61)
e Listening Mode Preset
(➔ 58)
MENU
1. Input/Output Assign
2. Speaker Setup
3. Audio Adjust
4. Source Setup
5. Listening Mode Preset
6. Miscellaneous
7. Hardware Setup
8. Remote Controller Setup
9. Lock Setup
a
b
c
d
e
f
g
h
i
1. Monitor Out
2. HDMI Input
3. Component Video Input
4. Digital Audio Input
5. Analog Audio Input
1. Input/Output Assign
1. Volume Setup
2. OSD Setup
3. 12V Trigger A Setup
4. 12V Trigger B Setup
5. 12V Trigger C Setup
6. Miscellaneous
1. Speaker Settings
2. Speaker Configuration
3. Speaker Distance
4. Level Calibration
5. Equalizer Settings
6. THX Audio Setup
2. Speaker Setup
1. Remote ID
2. Multi Zone
3. Tuner
4. HDMI
5. Auto Power Down
6. Network
7. Firmware Update
7. Hardware Setup
1. Multiplex/Mono
2. Dolby
3. DTS
4. Audyssey DSX
5. Theater-Dimensional
6. LFE Level
3. Audio Adjust
1. Remote Mode Setup
8. Remote Controller Setup
1. Audyssey
2. IntelliVolume
3. A/V Sync
4. Name Edit
5. Picture Adjust
4. Source Setup
Setup
9. Lock Setup
1. BD/DVD
2. VCR/DVR
3. CBL/SAT
4. GAME
5. PC
6. AUX
5. Listening Mode Preset
Common Procedures in Setup Menu
1
Press Receiver followed by Setup.
The following menu appears.
• If the main menu doesn’t appear, make sure the appropri-
ate external input is selected on your TV.
2
Use q/w to select a menu, and then press Enter.
3
Use q/w to select target and then press Enter.
4
Use q/w to select option and use e/r to change
the setting.
Press Setup to close the menu.
Press Return to return to the previous menu.
Return
Enter
q/w/e/r
Setup
Receiver
1. Input/Output Assign
2. Speaker Setup
3. Audio Adjust
4. Source Setup
5. Listening Mode Preset
6. Miscellaneous
7. Hardware Setup
8. Remote Controller Setup
9. Lock Setup
MENU
To Next Page
Loading...
Need help?
General
