3. Development Kit Setup
The instructions in this section explain how to setup the Cyclone V SoC Development
Kit for specific use cases.
3.1. Setting Up the Development Kit
To prepare the board, perform these steps:
1. The development board ships with its board switches preconfigured to support the
design examples in the kit. If you suspect your board might not be currently
configured with the default settings, follow the instructions in the Factory Default
Switch and Jumper Settings section to return the board to its factory settings
before proceeding.
The development board ships with the Golden System Reference Design (GSRD)
binaries stored in the microSD card.
The microSD card also includes the following:
•
Hardware reference design FPGA image, Raw Binary File (.rbf) file
• HPS image preloader U-Boot and Linux images
• File system and software examples
2. Power up the development board using the included power supply adapter. Make
sure that the power supply is connected to J40 if you are using the Power Solution
2 board (MMID: 99C5L6), and to J22 if you are using the Power Solution 1 board
(MMID: 979996).
Caution: Use only the supplied power supply. Power regulation circuitry on the
board can be damaged by power supplies with greater voltage, and a
lower-rated power supply may not be able to provide enough power for
the board.
Alternatively, you can use the an ATX power from a PC by plugging a 4-pin output
from that supply to J20 on the development board.
Caution: Make sure that the ATX supply is off when connecting to the board.
Hotswap is not supported and may damage the board's power supplies
and other downstream devices.
When configuration is complete, the Config Done LED (D38) illuminates, signaling that
the Cyclone V device configured successfully.
Related Information
• Factory Default Switch and Jumper Settings on page 15
• Restoring the MAX V CPLD to the Factory Setting on page 22
830285 | 2024.10.07
Send Feedback
©
Altera Corporation. Altera, the Altera logo, the ‘a’ logo, and other Altera marks are trademarks of Altera
Corporation. Altera and Intel warrant performance of its FPGA and semiconductor products to current
specifications in accordance with Altera’s or Intel's standard warranty as applicable, but reserves the right to
make changes to any products and services at any time without notice. Altera and Intel assume no
responsibility or liability arising out of the application or use of any information, product, or service described
herein except as expressly agreed to inwriting by Altera or Intel. Altera and Intel customers are advised to
obtain the latest version of device specifications before relying on any published information and before placing
orders for products or services.
*Other names and brands may be claimed as the property of others.
ISO
9001:2015
Registered
To Next Page
Loading...
