Chapter 2 – SettingUptheGatewayonaNetwork
17
2 Click Network Setup.
The following appears.
3 Click Set Up Network.
4 You must agree with the conditions of the license
agreement and click I Accept to continue.
The Network Setup screen appears.
5 Click OK to continue.
The Network Setup utility begins looking for the
gateway.
If you receive a message stating the AnyPoint
Network Setup Utility was unable to detect the
gateway, shut down then turn on your PC and start
over with step 1. If that does not work, see
Troubleshooting in the Installation Guide.
6 When you see the following Network Setup screen,
click Yes.
user_guide_rg1210.book Page 17 Monday, April 22, 2002 2:20 PM
To Next Page
Loading...
Need help?
General
