Chapter 3 – Changing the Gateway Settings
35
password your ISP provided you, then retype it to
verify.
• Host Name
– Applies only if you have a cable
modem. If your ISP requires you to enter a host
name, enter it exactly as it was given to you
• Domain Name
– Applies only if you have a cable
modem. If your ISP requires you to enter a domain
name, enter it exactly as it was given to you.
• WAN Ethernet MAC Address
– The WAN Ethernet
Media Access Control (MAC) address uniquely
identifies every device in the network. If your ISP
requires you to enter a MAC address, enter it exactly
as it was given to you.
Changing the
access point
setting
If you are not using the Intel Wireless Gateway to access
the Internet, but you want to extend your wired network
with wireless capability, choose the Access Point Mode.
This mode allows you to bridge your wireless PCs to your
Ethernet.
Step-by-step 1 From the main Wireless Gateway screen, click
Setup Wizard.
2 In the left column under the Setup Wizard,click
Device Settings.
Note Do not change these settings unless you are
instructed to do so by your broadband provider.
user_guide_rg1210.book Page 35 Monday, April 22, 2002 2:20 PM
To Next Page
Loading...
Need help?
General
