Intel SE7500CW2 - Page 68

System BIOS SE7500CW2 Server Board Technical Product Specification
56
Revision 1.40
Feature Choices Description
Reset Configuration
Data
No (default)
Yes
Specifies if the extended server configuration data
will be reset during the next boot.
Yes clears the extended server configuration data
during the next boot. The system automatically
resets this field to No during the next boot.
Large Disk Access Mode Other
DOS (default) UNIX
†
, NetWare
†
, and other operating systems
require this option be set to Other. If you install an
operating system and the hard drive fails to install,
change this setting and try again. Different
operating systems require different
representations of drive geometries.
PS/2 Mouse Disabled
Enabled
Auto Detect
(default)
Configures the PS/2 mouse.
Disabled prevents any installed PS/2 mouse from
functioning but frees up IRQ 12,
Enabled forces the PS/2 mouse port to be enabled
even if a mouse is not present.
Auto Detect will enable the PS/2 mouse only if one
is present.
Summary Screen Disabled
Enabled (default)
Enables or disables the boot-time hardware/BIOS
summary screen.
Legacy USB Support Disabled
Enabled (default)
Enables support for legacy USB. May be
necessary to “Disable” in order to install NetWare
6.0 SP1.
PXE Support Disabled (default)
NIC2
NIC1
Enables support for onboard PXE.
Hyper-Threading Disabled
Enabled (default)
Allows Intel Xeon processors to run in hyper-
threading mode. Enabling this setting will improve
throughput significantly on certain applications.