Intelligent Motion Systems IB Series - Options and Accessories

42
The motors are available in 3 stack sizes, single or double shaft, with or
without encoders. They handle currents up to 3 Amps in series or 6 Amps
parallel, and holding torque ranges from 95 oz-in to 230 oz-in (67 N-cm to
162 N-cm).
These CE rated motors are ideal for applications where higher torque is
required.
23 Frame High Torque Motors
Single Shaft Double Shaft
MH-2218-S.................................................................. MH-2218-D
MH-2222-S.................................................................. MH-2222-D
MH-2231-S.................................................................. MH-2231-D
Options and Accessories
See appendices for descriptions and technical data on these accessories.
Thermal Isolating Pad ....................................................TI-462
Thermal Non-Isolating Pad .........................................TN-462
Heat Sink ............................................................................H-4X
Interface Board ............................................................... OPT140
Plug-on Screw Terminal Set ............................................TS-6