WARNING
INSTALLATION AND CONFIGURATION SHOULD BE PERFORMED ONLY BY PERSONNEL WHO
ARE TECHNICALLY COMPETENT AND AUTHORIZED TO DO SO. LOCAL REGULATIONS
REGARDING ELECTRICAL INSTALLATION AND SAFETY MUST BE OBSERVED.
Failure to follow the instructions given can result in death or serious injury
WARNING
THE USE OF THIS EQUIPMENT IN A MANNER NOT SPECIFIED IN THIS MANUAL OR BY THE
MANUFACTURER MAY IMPAIR PROTECTION OF THE USER AND EQUIPMENT.
Failure to follow the instructions given can result in death or serious injury
CAUTION
THIS EQUIPMENT IS DESIGNED FOR INSTALLATION IN AN ENCLOSURE THAT PROVIDES
ADEQUATE PROTECTION AGAINST ELECTRIC SHOCK.
Failure to follow these instructions can result in personal injury.
NOTICE
The product is recognized as a component under c/UL/IEC 61010-1 and c/UL/IEC 61010-3 and has
been evaluated under IEC61000-6-5 in type 4 interface applications. The 61010-1 and -3 component
recognitions assume the following, which were not specifically evaluated for the product as a
component:
• Spacing of all wired components from energized conductors meets the greater of double
insulation under c/UL/IEC61010 or the BIL requirements of the host equipment.
• Wired sensors are installed and cabled in accordance with instructions.
Note that introduction of a recognized component into a previously recognized system requires
evaluation of the modified system for c/UL recognition.
Failure to follow these instructions can result in operation outside the c/UL recognition of the
product and/or host equipment.
To Next Page
Loading...
Need help?
General
