User Manual
910.00382.0001 May 2018
68
9.2.3 Federal Communications Commission (FCC)
This product contains FCCID: 2AEAE-ISAW-RF-H0215
The design of the CAM-5 complies with U.S. Federal Communications Commission (FCC) guidelines
respecting safety levels of radio frequency (RF) exposure for fixed location devices.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to part 15 of the FCC Rules when the unit is professional installed in metal enclosures described in the
IEEE standard C37.20. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference in which case the user will be required to
correct the interference at his own expense.
9.2.3.1 Installation Requirements
The IntelliSAW CAM-5 and approved Air Interfaces can be professionally installed in the following
installation environments:
1. Metal enclosures described in the IEEE/ANSI Std C37.20, or UL and NEMA specifications
derived from Std C37.20, as indicated in KDB 550099.
a. The CAM-5 HMI is not required to be in such an enclosure since the Air Interface is wired
away from the host.
b. The CAM-5 HMI firmware shall be configured for ANSI
2. Open air operation
a. The Air Interface and CAM-5 can operate outside of the metal enclosures when the CAM-
5 firmware is configured for Open Air operation.
Changes or modification to the equipment not expressly approved by IntelliSAW could void the
user's authority to operate the equipment.
9.2.4 Industry Canada (IC)
This product contains device certified under IC: 11526A-ISAWRFH0215
This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the
following conditions:
• This device may not cause harmful interference.
• This device must accept any interference received, including interference that may cause
undesired operation.
Changes or modification to the equipment not expressly approved by IntelliSAW could void the user's
authority to operate the equipment
To Next Page
Loading...
Need help?
General
