D-0120578-C – 2019/11
Eclipse – Instructions for Use - US
Page 101
8
8
8 Operating instructions ASSR
8.1 Using the ASSR module
1. All contact between the conductive parts of electrodes or their connectors, including the neutral
electrode and other conductive parts including the earth must be avoided.
2. Please check the setup before recording and verify that the correct stimulus rate and stimulus level
will be used as another operator/person may have changed/deleted the protocol setting. During
recording the stimulus rate and level can be seen on the user interface.
3. If the system has not been used for a while, the operator should inspect the transducers (e.g,. check
the insert phone silicone tubing for cracks) and electrodes (e.g., check the expiry date of the
disposable electrodes, check cables for damage) to verify that the system is ready to start testing
and provide accurate results.
4. Only electrode gel intended for electroencephalography must be used. Please follow the
manufacturer’s instructions regarding the use of the gel.
5. The presence of tinnitus, hyperacusis or other sensitivity to loud sounds may contraindicate testing
when high intensity stimuli are used.
NOTICE
1. The Eclipse system consists of a 2-channel input board which allows the user to create
measurements for both ears without switching the electrodes.
2. In the case of tense patient muscles, particularly in the region of the neck, nape and shoulders, the
quality of the recordings may be poor or completely rejected. It may be necessary to reinstruct the
patient to relax and then resume testing when the muscles have relaxed.
To Next Page
Loading...
Need help?
General
