Interface GOLD STANDARD - Software Functions and Data Handling

7418 East Helm Drive • Scosdale, Arizona 85260 • 480.948.5555 • www.interfaceforce.com
Page 22 of 45

Allows manual control of command voltage for controlling hydraulic frame.

A set point le must be loaded before using Auto Hydraulic Adjust. Select Load Set Points buon and
select desired set point le.

Select desired voltage increment/decrement buons to adjust command voltage as desired. Maximum
voltage limits in set point le are applied.

Allows eding of set point les without performing calibraon. See Calibraon Set point le creaon.

Allows deleon of undesired calibraon runs from selected le.

Records the Zero Balance for all meters and saves results in the folder as dened by ZeroPath in the WGoldCFG
program.

If displayed from the Analysis menu:
Select the desired le.
Select the desired calibraon run(s).
If displayed from either Analysis menu or during calibraon cycle:
The system will now display a ed curve output and error as well as the curve coecients and standard
deviaon.
The following buons are displayed in the lower right corner.
SCREEN
Switches the display to 1 of 3 screens.
PRINTER
Generates a hard copy of all 3 display screens.
A menu will be displayed to select the desired report to print. These reports are created using the Report
Designer found on the Tools menu from the main screen.

Displays a best t polynomial curve plot of up to 8 runs.