11
8. Turn the face panel downward until the switch button drops out.
9. Place the left side of the new face panel near the left, front of the chassis and orient the
switch so that the black and green wires are at the bottom.
10. Push the switch into the mount until it snaps into place.
11. Place the switch button into its hole and push firmly until it seats.
12. Align the new face panel with the tab notches and light pipe guides, and carefully push
the panel onto the chassis until all tabs engage.
13. Install the door, left and right side panels, and top cover.
To replace the left or right side plastic cowling:
1. Remove the top cover, then remove the side panel that has the plastic you want to
replace. See Chapter 1, “Accessing the System,” for details.
2. Place the side panel, with the cowling side down, on a flat, padded surface.
3. Remove the screw that secures the plastic to the side panel.
4. Grasp one side of the panel, press the release tabs, and lift the panel off the plastic.
5. Turn the side panel over and press the new plastic onto the panel until the release tabs
engage.
6. Turn the side panel over and install the screw.
7. Install the side panel onto the chassis.
8. Install the top cover. See Chapter 1, “Accessing the System,” for details.
Peripheral Drives
This section explains how to replace the floppy, CD-ROM, and internal and external bay
disk drives. See Chapter 6, “Peripherals,” for details on drive configuration and cables.
Floppy Disk Drive
To replace the floppy disk drive:
1. Disconnect the power cable and data cable from the drive. Note the position of the red
stripe on the data cable.
2. Remove the two screws that secure the floppy drive to the chassis. See the following
figure.
To Next Page
Loading...
