Interlogix ZeroWire User Manual

46 ZeroWire User Manual
5. Initiate LINK or ADD mode on Z-Wave device. See your Z-Wave device’s manual for
instructions.
Note: If a Z-Wave device has previously been added to another system, you must first
remove it before adding it to this system. To do this, click Remove, then activate LINK
or REMOVE mode on the device.
6. Click Rooms
7. Check you can see the device you just added. Click a button such as ON or OFF to
verify you can control the device.

Interlogix ZeroWire Specifications

General

Brand	Interlogix
Model	ZeroWire
Category	Security System
Language	English