ZeroWire User Manual 15
You may arm your system by entering your user PIN code:
1.
STATUS
Check status key is green. Close all
protected doors and windows. If you
have motion detectors outside your “stay
mode”, have everyone leave those
areas.
2.
STAY
Select the Stay Mode.
3.
4.
Stay within the protected areas.
Or, if your service provider has enabled the quick arm feature, you can simply touch the
Stay key:
5.
STATUS
Check status key is green. Close all
protected doors and windows. If you
have motion detectors outside your
“stay mode”, have everyone leave
those areas.
6.
STAY
Select the Stay Mode.
7.
Stay within the protected Stay or Night
Mode areas.
If an armed zone is alarmed whilst your security system is in the Stay mode, it will sound a
warning tone on your ZeroWire and start a timer. At the end of the Stay Mode Entry Time
your sirens will sound. Your service provider predetermines this warning time at the time of
installation.
Downstairs only
protected
Touch Stay
Ready Light
is green
To Next Page
Loading...
