Interlogix ZeroWire - Page 7

16 ZeroWire User Manual
To start the Stay Instant Mode touch the Stay key twice:
1.
STATUS
Check status key is green. Close all
protected doors and windows. If you
have motion detectors outside your
“stay mode”, have everyone leave
those areas.
2.
STAY STAY
Select the Stay Mode twice.
Or press Stay button once when
system is already in Stay Mode. In this
case, you will not be asked second time
for a PIN code.
3.
STAY
(flashing yellow)
Stay button will flash on and off.
Stay within areas protected with Stay
Mode or Night Mode zones.
If an armed zone is alarmed whilst your security system is in the Stay mode there will be
no warning timer and your sirens will sound immediately.
To start the Night Mode touch the Stay key three times:
1.
STATUS
Check status key is green. Close all
protected doors and windows. If you
have motion detectors outside your
“stay mode”, have everyone leave
those areas.
2.
STAY STAY STAY
Select the Stay Mode three times.
Or when system is already in Instant
Stay Mode, press Stay once. In this
case you will not be asked second time
for a PIN code.
3.
STAY
(flashing red)
Stay button will flash on and off.
Stay within areas protected with Stay
Mode zones. Do not move into areas
protected with Night Mode zones.
If an armed zone is alarmed whilst your security system is in the Stay mode there will be
no warning timer and your sirens will sound immediately.
To set normal Stay Mode, touch the Stay key one more time:
1.
STAY
Select the Stay Mode when the system
is in Night Mode.
2.
STAY
Stay button will return to a solid yellow.
Stay within the protected areas.