Chapter 10 — Troubleshooting
EasyCoder PF2i Bar Code Label Printer User’s Guide (Fingerprint Version) 95
LSS too low Blink 1008
Testfeed not done Blink 1606
Pause Mode entered Blink
Setup Mode entered Blink Including interactive
setup from Fingerprint/
Direct Protocol
IP link error Blink See note 1, 2, and 3
IP configuration error Blink See note 1, 3, and 4
Generic DP error Blink See note 5
Press any key to
continue
Blink See note 6
Application load error Blink See note 7
IRI blink by
application
Blink Set by Fingerprint
instruction SYSHEALTH
IRI off by application Off Set by Fingerprint
instruction SYSHEALTH
Application break Off See note 8
Printhead not found Off
Rebooted Off
Initializing Off Set at startup until
operational
Printer crash Off See note 3 and 9
Printer turned off Off
Maintenance Off Set when upgrading
Power supply Over
temperature
Off 1718
Note 1: This is only applicable for printers equipped with an EasyLAN
interface.
Note 2: A printer that is equipped with an EasyLAN interface, but is not
connected to a network, will have a blinking IRI. To avoid this, the user
can set “IP SELECTION” to “MANUAL” and “IP ADDRESS” to
“0.0.0.0”. This will indicate that the user does not regard the lack of
network connection as an error.
Note 3: No trap can be sent when this error/event occurs.
Display Messages and LED Indications (continued)
Error/Event IRI Error No. Comment
To Next Page
Loading...
