Intermec EasyCoder PF2i User Manual

Chapter 6 — Setting Up the Printer
EasyCoder PF2i Bar Code Label Printer User’s Guide (Fingerprint Version) 53
• 4800
• 9600 (default)
• 19200
• 38400
• 57600
• 115200
Data Bits
The data bits parameter specifies the number of bits that will
define a character. Eight bits are recommended, because that
option allows more special characters and characters specific to
foreign languages to be used. Refer to the Intermec Fingerprint
v8.xx, Command Reference Manual for more information.
• 7: Characters ASCII 000 to 127 decimal
• 8: Characters ASCII 000 to 255 decimal (default)
Parity
The parity decides how the firmware will check for transmission
errors. There are five options:
• None (default)
• Even
• Odd
•Mark
• Space
Stop Bits
The number of stop bits specifies how many bits will define the
end of a character. There are two options:
•1 (default)
•2
Flow Control
RTS/CTS is a protocol where the communication is controlled
by currents through separate lines in the cable being set either to
high or low. By default, this option is disabled.

Intermec EasyCoder PF2i Specifications

General

Brand	Intermec
Model	EasyCoder PF2i
Category	Printer Accessories
Language	English