Chapter 12 — Adjustments
116 EasyCoder PF2i Bar Code Label Printer User’s Guide (Fingerprint Version)
Narrow Media Adjustment
The printer is factory-adjusted for full-size media width. When
using media less than full width, it is recommended that you
adjust the position of the pressure arm, so it becomes centered
with the media. Thereby, an even pressure across the media is
obtained.
A poorly adjusted pressure arm may be detected by a weaker
printout on either side of the media path.
To adjust the pressure arm, proceed as follows:
1 Loosen the straight-slot screw that holds the pressure arm.
2 Move the arm inwards or outwards until the arrow on the tip
of the arm becomes centered with the media.
While moving the arm, push at the part where the screw is
situated, not at the tip. If the arm is hard to move, lift the
printhead and pull the printhead bracket free from the
magnet in the arm.
3 After having centered the arm, lock it by tightening the screw.
To Next Page
Loading...
Need help?
General
