Appendix B — Media Specifications
EasyCoder PF2i Bar Code Label Printer User’s Guide (Fingerprint Version) 137
Self-Adhesive Labels
⇐ a ⇒ Media Width (including liner)
Maximum: 60.0 mm (2.36 inches)
Minimum (standard): 25.0 mm (1.00 inches)
Minimum (quick-load): 40.0 mm (1.57 inches)
⇐ b ⇒ Liner
The backing paper must not extend more than a total of 1.6 mm
(0.06 inches) outside the labels and should protrude equally on
both side. Recommended minimum transparency: 40%
(DIN 53147).
⇐ c ⇒ Label Width (excluding liner)
Maximum: 58.4 mm (2.30 inches)
Minimum: 23.8 mm (0.94 inches)
⇐ d ⇒ Label Length
Maximum: depends on SDRAM size
Minimum: 8.0 mm (0.32 inches)
Under ideal circumstances, a minimum label length of 4 mm
(0.16 inches) could be used. It requires the sum of the label
length (d) and the label gap (e) to be larger than 7 mm (0.28
inches), that batch printing is used, and that no pull back of the
media is performed. Intermec does not guarantee that such short
labels will work, but it is up to the user to test this in his unique
application.
⇐ e ⇒ Label Gap
Maximum: 21.3 mm (0.83 inches)
Recommended: 3.0 mm (0.12 inches)
Minimum: 1.2 mm (0.05 inches)
The Label Stop Sensor must be able to detect the extreme front
edges of the labels. It can be moved between 5 fixed positions (see
“Label Stop Sensor (LSS) Position Adjustment” on page 118).
Media Type Setup
•Label (with gaps)
To Next Page
Loading...
Need help?
General
