Intermec EasyCoder PF2i User Manual

Chapter 6 — Setting Up the Printer
EasyCoder PF2i Bar Code Label Printer User’s Guide (Fingerprint Version) 51
Default Setup
The printer’s default setup is listed below (no options included):
Ser-Com “uart1:”
Baud rate 9600 bps
Data bits 8 bits
Parity None
Stop bits 1 bit
RTS/CTS Disable
ENQ/ACK Disable
XON/XOFF, data to host Disable
XON/XOFF, data from host Disable
New line CR/LF
Receive buffer 1024 bytes
Transmit buffer 1024 bytes
Media
X-Start 24
Width 424
Label length 1200
Media type Label (with Gaps)
Paper type Direct Thermal
Label Constant 85
Label factor 40
Contrast ±0%
Configuration
Print speed 100 mm/sec.
Feed Adjust
Start adjust 0
Stop adjust 0

Intermec EasyCoder PF2i Specifications

General

Brand	Intermec
Model	EasyCoder PF2i
Category	Printer Accessories
Language	English