Chapter 4 — Media Load
30 EasyCoder PF2i Bar Code Label Printer User’s Guide (Fingerprint Version)
11 To tear off the media, grab the outer edge and pull
downwards.
Tear-Off With Quick-Load (Straight-Through)
In addition to the media load procedure for tear-off (straight-
through) operation described earlier in this chapter, the
EasyCoder PF2i printer can optionally be fitted with a set of
quick-load guides that makes media load much easier and
quicker, especially if the printer has a short side door. See
“Adjustments” on page 115 for installation instructions.
Quick-load cannot be combined with peel-off (self-strip)
operation.
Use the Feed key when loading the same type of media. When
switching to a new type of media, or if the printer does not feed
out the media properly, simultaneously press the Shift and Feed
keys to perform a “testfeed.”
An optional label taken sensor can hold the printing of the next
copy in the batch until the present copy has been removed, see
“Label Taken Sensor” on page 91.
Note: Full automatic loading, without the operator having to
press any key, requires a special set of Intermec Fingerprint
instructions in the application program.
To Next Page
Loading...
Need help?
General
