Intermec EasyCoder PF2i User Manual

Chapter 6 — Setting Up the Printer
60 EasyCoder PF2i Bar Code Label Printer User’s Guide (Fingerprint Version)
When adjusting the image darkness for non-Intermec direct
thermal media, set the Label Factor to the recommended value
for the type of direct thermal media. Set the Label Constant to
the value listed below and decrease or increase it for lighter or
darker images respectively until you are satisfied with the
printout quality.
Thermal Transfer Printing
• Ribbon Constant (range 50 to 115)
• Ribbon Factor (range 10 to 50)
• Label Offset (range -50 to 50)
• Ribbon Sensor (auto-adjustment)
• Low Diameter (range 25 to 80 mm)
When adjusting the image darkness for non-Intermec media and
transfer ribbons, set the Ribbon Factor to the recommended
value for the type of thermal transfer ribbon. Set the Ribbon
Constant to the value listed below and decrease or increase it for
lighter or darker images respectively until you are satisfied with
the printout quality. The Label Offset parameter is presently not
used, so keep it at the default value 0.
General Paper Type Settings Guide (Direct Thermal)
Sensitivity
1
Label Constant Label Factor
Max. Print
Speed
Low 100 50 150
Standard 90 50 150
High 80 50 200
Ultra High 70 50 200
1. Note that the preprint and varnish decrease the sensitivity of direct
thermal media.
General Paper Type Settings Guide (Thermal
Transfer)
Type
Ribbon
Constant
Ribbon
Factor
Max. Print
Speed
Wax (Europe) 70 25 150
Wax (U.S.A.) 70 25 150

Intermec EasyCoder PF2i Specifications

General

Brand	Intermec
Model	EasyCoder PF2i
Category	Printer Accessories
Language	English