Chapter 6 — Setting Up the Printer
66 EasyCoder PF2i Bar Code Label Printer User’s Guide (Fingerprint Version)
3 Quickly press the following keys in this order:
d/F4, c/F2, c/F2, e/F1
4 The following message will be displayed:
5 Within 10 seconds, press Enter to reset the printer to factory
default. The parameters will be reset and the printer will
continue the normal startup.
If you press c/F2 or wait until the 10 seconds timeout has
passed, the normal startup will continue without any reset being
performed.
Factory Default?
Enter=Yes ESC=No
Note: If any of the files "card:NOSHELL.CFG",
rom:NOSHELL.CFG", or "c:NOSHELL.CFG"exists in the
printer’s memory, no reset to factory default will be performed.
The factory default will remove all files used to store settings. It
will not reset settings that already has been read when the files are
removed. This means that EasyLAN Wireless settings (SSID,
keys, etc.) will retain their values from the previous start.
However, the next reboot will reset them to factory default.
To Next Page
Loading...
