Intermec EasyCoder PF2i User Manual

Chapter 7 — Setup Mode
70 EasyCoder PF2i Bar Code Label Printer User’s Guide (Fingerprint Version)
The Setup Mode is organized as an endless loop, from which you
can select a number of sub-categories. At startup, the firmware
determines if options such as a label taken sensor, a cutter, or an
interface board is installed in the printer. Only installed options
are shown in the Setup Mode.
The diagram below shows the options in the main loop. Detailed
overviews are shown on the pages that follow.
SETUP:
SER-COM, UART1
SETUP:
PRINT DEFS
Option
SETUP:
MEDIA
SETUP:
FEEDADJ
SETUP:
NETWORK
SETUP:
NET-COM, NET1
Option
SETUP:
SER-COM, UART3
Option
SETUP:
SER-COM, UART2
Option
Starting point

Intermec EasyCoder PF2i Specifications

General

Brand	Intermec
Model	EasyCoder PF2i
Category	Printer Accessories
Language	English