Intermec SG20T

Chapter 3 — SG20T Interfaces
SG20T Tethered Scanner User’s Guide 21
Hungarian 101-Key
USB Cable Mode
By default the USB cable mode is set to keyboard HID. However you
can also set up your scanner to use the following USB cable modes:
• HID POS
• IBM POS Hand Held
• IBM POS Table Top
• Virtual COM
USB Keyboard HID (*)
HID POS
IBM POS Hand Held
IBM POS Table Top
USB Virtual COM
Note: When scanning a USB Cable Mode configuration bar code, the
scanner beeps twice then restarts. When it restarts it will beep twice
and flash a series of green flashes to indicate the USB cable mode (see
“Status Light” on page 11).