Intermec SG20T User Manual

Chapter 4 — Configuring the SG20T Scanner
28 SG20T Tethered Scanner User’s Guide
Basic Setup with Configuration Bar Codes
This chapter provides you with configuration bar codes for a basic
setup. For more configuration options, use EasySet (see
“Configuring Your System with EasySet” on page 31).
Resetting Your Scanner
To reset your scanner, read the reset factory defaults configuration
bar code.
Reset factory defaults
Configuring the Postamble
The default postamble is <CR> <LF>. For certain applications or
when using USB Keyboard HID you may need to change this setting.
Use the following configuration bar codes to change the default
postamble in your scanner.
Carriage Return + Line Feed (*)
None
Carriage Return
Enter

Intermec SG20T Specifications

General

Type	Handheld bar code reader
Sensor type	-
Scanner type	1D
Optical sensor resolution	- pixels
Linear (1D) barcodes supported	Codabar, Code 11, Code 128, Code 39, Code 93, GS1-128 (UCC/EAN-128), Plessey, Telepen, U.P.C.
2D (matrix & stacked) barcodes supported	Not supported
Standard interfaces	USB
Connectivity technology	Wired
Product color	Gray
Built-in display	No
International Protection (IP) code	IP30
Input voltage	5 V
Power consumption	120 mA
Power source type	DC
Storage temperature (T-T)	-20 - 60 °C
Operating temperature (T-T)	0 - 50 °C
Operating relative humidity (H-H)	5 - 95 %

Weight and Dimensions

Depth	200 mm
Width	61 mm
Height	65 mm
Weight	125 g