Intermec SG20T User Manual

Chapter 4 — Configuring the SG20T Scanner
SG20T Tethered Scanner User’s Guide 29
Hands-Free Scanning
For hands-free scanning as explained in “Hands-Free Scanning” on
page 15 activate Autostand triggering mode by scanning this
configuration bar code:
Autostand Triggering Mode
Optimizing Decoding
Use the following barcodes to optimize your scanner reading
performance.
Damaged 1-Dimensional Bar Codes
If you are reading 1D bar codes that are damaged or badly printed,
enable this setting to enhance the ability to read these types of bar
codes.
Damaged 1D Codes - Enable
Damaged 1D Codes - Disable (*)
Note: These configuration bar codes are only for the SG20THP and
SG20THPHC models.

Intermec SG20T Specifications

General

Type	Handheld bar code reader
Sensor type	-
Scanner type	1D
Optical sensor resolution	- pixels
Linear (1D) barcodes supported	Codabar, Code 11, Code 128, Code 39, Code 93, GS1-128 (UCC/EAN-128), Plessey, Telepen, U.P.C.
2D (matrix & stacked) barcodes supported	Not supported
Standard interfaces	USB
Connectivity technology	Wired
Product color	Gray
Built-in display	No
International Protection (IP) code	IP30
Input voltage	5 V
Power consumption	120 mA
Power source type	DC
Storage temperature (T-T)	-20 - 60 °C
Operating temperature (T-T)	0 - 50 °C
Operating relative humidity (H-H)	5 - 95 %

Weight and Dimensions

Depth	200 mm
Width	61 mm
Height	65 mm
Weight	125 g