Intermec SG20T

Chapter 3 — SG20T Interfaces
24 SG20T Tethered Scanner User’s Guide
The default serial parameters for the SG20T are:
Setting up the RS-232 Interface
This section provides configuration bar codes for a basic setup. All bar
codes marked with (*) indicate the default value. For more
configuration options see
Chapter 4, "Configuring the SG20T
Scanner” on page 27.
Baud Rate
38400
57600 (*)
115200
128000
230400
256000
Serial Parameter Default Setting
Baud rate 57600
Data bits 8
Parity None
Stop bits 1