International Electronics prox.pad plus - Page 89

Action Press Details
20. Enable/disable
users
56 # enable/disable # user # **
0 = Enables that
user
1 = Disables that
user;
Master user cannot
be disabled; an
unprogrammed user
cannot be enabled
or disabled
(generates a
program error)
21. Program block
of 26-bit “card only”
users without
presenting cards
57 # number of users # start user #
card pin * card pin *
Start user MUST b e
greater than 2;
Master/Supervisor
cannot be set as
“card only”; uses
site ID set in
command 32,
parameter 4
22. Delete block of
consecutive users
58 # start user # start user # number of
users * number of users *
23. Dump
transactions to IR
port
70#0#0#**
This command
MUST be used
while in Program
mode
4.6 Programming Commands Chapter 4: Programming
prox.pad plus Install/Program. Manual, PPP, D2 4-39