113
13.2.3
Repairing a flat tyre (pneumatic tyres type 3.00-8")
Requirements:
• Allen key 5 mm
• Repair kit for inner tubes or an new inner tube.
• Talcum powder
Remove the wheel
• Jack the vehicle up and place a block of wood
underneath it to prop it up.
• Remove the 4 countersunk screws (1).
• Remove the wheel from the hub.
NOTE
Re-assembly is done in reverse order. Make sure that the wheel is put back on the same side it
was on, and that it runs in the same direction it did before it was removed.
To Next Page
