87
10.2.3.2 Height Adjustment for Ergonomic Length Compensation
Warning: Danger of Injury if footrest or legrest is incorrectly adjusted!
• Before and during each drive, always make sure there is sufficient clearance between the
legrest (or footrest) and the ground, as well as the castors!
Ergonomic Length Compensation of the legrest is only given if the pivot point
of the legrest (1) corresponds with that of the user's knee.
To insure this, the height of the pivot point of the legrest must be adjusted to
suit the user.
• Loosen and remove the screws (2) using a 5mm Allen Key.
• Adjust the height of the legrest, align it with the holes (3) and reposition
the screws.
• Tighten the screws (2) and test the clearance of the legrest.
NOTE:
Adjustment of the height should only be done by authorised
technicians.
To Next Page
Loading...
