Invertek Drives OPTIDRIVE P2 Series - Routine Maintenance

OptidriveODP‐2UserGuideRevision1.30

www.invertekdrives.com
17

3 MechanicalInstallation
3.9.4. FrameSize6
Removethetwoscrewsindicated,liftthecoverforwardsandoff.Torefitthecover,slidethetoplocatinglugsupwardsunderthetopcover,
thenre‐fastenthelowercoverscrews

3.10. RoutineMaintenance
Thedriveshouldbeincludedwithinthescheduledmaintenanceprogramsothattheinstallationmaintainsasuitableoperatingenvironment,
thisshouldinclude:
• Ambienttemperatureisatorbelowthatsetoutinthe“Environment”section.
• Heatsinkfansfreelyrotatinganddustfree.
• TheEnclosureinwhichthedr
iveisinstalledshouldbefreefromdustandcondensation;furthermoreventilationfansandairfilters
shouldbecheckedforcorrectairflow.

Checksshouldalsobemadeonallelectricalconnections,ensuringscrewterminalsarecorrectlytorqued;andthatpowercableshavenosigns
ofheatdamage.
