Invertek Drives OPTIDRIVE P2 Series - Page 5

OptidriveODP‐2UserGuideRevision1.30

www.invertekdrives.com
5

1 Introduction
DeclarationofConformity:
InvertekDrivesLimited
OffasDykeBusinessPark
Welshpool
Powys
UK
SY218JF
InvertekDrivesLtdherebystatesthattheOptidriveODP‐2productrangeconformstotherelevantsafetyprovisionsoftheLowVoltage
Directive2006/95/ECandtheEMCDirective2004/108/ECandhasbeendesignedandmanufacturedinaccordancewiththefollow
ing
harmonisedEuropeanstandards:
EN61800‐5‐1:2003 Adjustablespeedelectricalpowerdrivesystems.Safetyrequirements.Electrical,thermalandenergy.
EN61800‐32
nd
Ed:2004 Adjustablespeedelectricalpowerdrivesystems.EMCrequirementsandspecifictestmethods
EN55011:2007 LimitsandMethodsofmeasurementofradiodisturbancecharacteristicsofindustrial,scientificandmedical(ISM)
radio‐frequencyequipment(EMC)
EN60529:1992 Specificationsfordegreesofprotectionprovidedbyenclosures
SafeTorqueOFF(“STO”)Function
OptidriveP2incorporatesahardwareSTO(SafeTorqueOff)Function,designedinaccordancewiththestandardslistedbelow.
Standard Classification IndependentApproval
EN61800‐5‐2:2007 Type2
*TUV
ENISO13849‐1:2006 PL“d”
EN61508(Part1to7) SIL2
EN60204‐1 UncontrolledStop“Category0”
EN62061 SILCL2
*Note:TUVApprovalofthe“STO”functionisrelevantfordriveswhichhaveaTUVlogoappliedondriveratinglabel.
ElectromagneticCompatibility
AllOptidrivesaredesignedwithhighstandardsofEMCinmind.AllversionssuitableforoperationonSinglePhase230voltandThreePhase400
voltsuppliesandintendedforusewithintheEuropeanUnionarefittedwithaninternalEMCfilter.ThisEMCfilterisdesignedtoreducethe
conductedemission
sbackintothesupplyviathepowercablesforcompliancewithharmonisedEuropeanstandards.
Itistheresponsibilityoftheinstallertoensurethattheequipmentorsystemintowhichtheproductisincorporatedcomplieswith theEMC
legislationofthecountryofuse.WithintheEuropeanUnion,equipmentintowh
ichthisproductisincorporatedmustcomplywiththeEMC
Directive2004/108/EC.WhenusinganOptidrivewithaninternaloroptionalexternalfilter,compliancewiththefollowingEMCCategories,as
definedbyEN61800‐3:2004canbeachieved:
DriveType/Rating EMCCategory
CatC1 CatC2 CatC3
1Phase,230VoltInput
ODP‐2‐x2xxx‐1xFxx‐xx
Noadditionalfilteringrequired
Useshieldedmotorcable
3Phase,400VoltInput
IP20&IP66Models
ODP‐2‐x4xxx‐3xFxx‐xx
UseAdditionalExternalFilter Noadditionalfilteringrequired
UseShieldedMotorCable
3Phase,400VoltInput
IP55Models
ODP‐2‐x4xxx‐3xFxN‐xx
UseAdditionalExternalFilter NoAdditionalFilteringRequired
UseShieldedMotorCable
3Phase,525&600VoltInput
ODP‐2‐x5xxx‐3x0xx‐xx
ODP‐2‐x6xxx‐3x0xx‐xx
ThesemodelsareexcludedfromtheD eclarationofconformitytoehEMCDirective.Compliancemayrequiretheuseof
additionalEMCfilters,contactyourlocalSalesPartnerforfurtherassistance
Note
CompliancewithEMCstandardsisdependentonanumberoffactorsincludingtheenvironmentinwhichthedriveisinstalled,motorswitching
frequency,motor,cablelengthsandinstallationmethodsadopted.

Formotorcablelengthsgreaterthan100m,anoutputdv/dtfiltermustbeused,pleaserefertotheInvertekStockDrivesCatalogueforfurther
details
VectorSpeedandTorquecontrolmodesmaynotoperatecorrectlywithlongmotorcablesandoutputfilters.ItisrecommendedtooperateinV/F
modeonlyforcablelengthsexceeding50m
Allrightsreserved.NopartofthisUserGuidemaybereproducedortransmittedinanyformorbyanymeans,electricalormechanicalincluding
photocopying,recordingorbyanyinformationstorageorretrievalsystemwithoutpermissioninwritingfromthepublisher.
CopyrightInvertekDrivesLtd©2013
AllInvertekOptidriveP2unitscarrya2yearwarrantyagainstmanufacturingdefectsfromthedateofmanufacture.Themanufactureraccepts
noliabilityforanydamagecausedduringorresultingfromtransport,receiptofdelivery,installationorcommissioning.Themanufactureralso
acceptsnoliabilityfordamageorconsequencesresultingfrominappropriate,neglig
entorincorrectinstallation,incorrectadjustmentofthe
operatingparametersofthedrive,incorrectmatchingofthedrivetothemotor,incorrectinstallation,unacceptabledust,moisture,corrosive
substances,excessivevibrationorambienttemperaturesoutsideofthedesignspecification.

Thelocaldistributormayofferdifferenttermsandconditionsattheirdiscretion,andinallcasesconcerningwarranty,thelocaldistributor
shouldbecontactedfirst.

Thisuserguideisthe“originalinstructions”document.Allnon‐Englishversionsaretranslationsofthe“originalinstructions”.
ContentsofthisUserGuidearebelievedtobecorrectatthetimeofprinting.Intheinterestofacommitmenttoapolicyofcontinuous
improvement,themanufacturerreservestherighttoch
angethespecificationoftheproductoritsperformanceorthecontentsoftheUser
Guidewithoutnotice.
ThisUserGuideisforusewithversion1.30Firmware. UserGuideRevision1.30
InvertekDrivesLtdadoptsapolicyofcontinuousimprovementandwhilsteveryefforthasbeenmadetoprovideaccurateanduptoda
te
information,theinformationcontainedinthisUserGuideshouldbeusedforguidancepurposesonlyanddoesnotformthepartofany
contract.
 