User manual of EC160 elevator intelligent integrated machine Function parameters
108
H3 rear door stopping floor
H4 front/ rear door
stopping floor
L0 parallel and group
control setting
Logic setting 1 is the logic setting of the following signals:
Terminal P8 P7 P6 P5 P4 P3 P2 P1
Definition
Up
limit
Down
limit
High speed
up forced
deceleration
signal
High speed
down forced
deceleration
signal
Medium
speed up
forced
deceleration
signal
Medium
speed down
forced
deceleration
signal
Low speed
up forced
deceleration
signal
Low speed
down forced
deceleration
signal
NO/NC ● ● ● ● ● ● ● ●
Binary 1 1 1 1 1 1 1 1
Decimal 1×128 1×64 1×32 1×16 1×8 1×4 1×2 1×1
H0_00
Logic
setting 1
128+64+32+16+8+4+2+1=255
1 to 8 (from low bit to high bit) are shown in binary numbers. The corresponding bit of NO points set
to be 0 and the NC to be 1. Write the convertering decimal result to logic 1.
Above switches are NC, which can be shown in binary 11111111, converted into decimal
(1+2+4+8+16+32+64+128)=255.
Logic setting 2 is the logic setting of the following signals:
Terminal P16 P15 P14 P13 P12 P11 P10 P9
Definition
Safety
contactor
detection
Middle
door
area
Down
door
area
Up
door
area
Inspection
down
signal
Inspection
up signal
Inspection
signal
Emergency
electric
running
NO/NC ○ ○ ○ ○ ○ ○ ● ●
Binary 0 0 0 0 0 0 1 1
Decimal 0×128 0×64 0×32 0×16 0×8 0×4 1×2 1×1
H0_01
Logic
setting 2
2+1=3
9 to 16 (from low bit to high bit) are shown in binary numbers. The corresponding bit of NO points
To Next Page
Loading...
